A "Two Cut Corner" cover can be either square or rectangular. Be sure the measurement specified for Y is also parallel to the direction of the hinge! It's important to choose either A or B depending upon the hinge configuration. Typically the diagonal cut, Z, is the same for both corners and will be specified in steps 3 and 4. If not, we will require a diagram.
If the two uncut corners are rounded please specify the radius in the special instructions section.
Measurement w, while shown in the above left diagram, is not required for us to make a proper fitting cover.
| In some cases it may be difficult to measure
the diagonal Z and may be easier to determine Z based on the picture and chart below. |
|||||||||||||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||||||||